1.Introduction Mostly in the form of inductive load of power system, will consume reactive power, makes the phase lag of the load current to voltage, phase Angle difference, the greater the reactive power demand, the greater the supply proper active power, is bound to increase current and increase the line loss. At the same time, it is often impossible for these reactive power to be supplied by generators and passed over long distances unreasonably. A reasonable method is to generate reactive power in a place where reactive power is needed. Therefore, capacitors are almost used in the distribution system to compensate for the reactive power required by the load to improve the power factor. Reactive compensation for reactive power compensation can receive the following effects: Mixer to reduce power loss, general factory power wiring according to different line and load conditions, the power loss of about 2% one 3%, after using capacitance improve power factor, reduce the total current…

Similar

FSL-CCX dense busbar system
GGXM segregated phase common enclosure bus
FSL-GM Common Enclosure Busbar Trunking
FSL-ZM series lighting bus duct
FSL-FSMC series cast bus duct
FSL-NHMC series fire-resistant bus ducts
FSL-CFW series air-type bus duct
FSL- YB box substation
internal metal armor extraction switch equipment
FSL-JXF cable branch box
FSL-XL power distribution box
FSL-ATS double power box

Jiangsu Fansheng Electrical Technology Co.,Ltd.

Since its establishment in March 2008, Jiangsu Fansheng Electrical Technology Co., Ltd. has dedicat…

Copyrights © 2026 astszcmparts.com All Rights.Reserved .