Custom DB44 connector overmolded industrial wiring harness

Custom DB44 Connector Overmolded Industrial Wiring Harness   This harness terminates a 44-position high-density D-sub — three rows of contacts inside the familiar trapezoidal shell — and then forms the whole back end into a single moulded body. The contacts are crimped or soldered, seated in the shell, and the assembly is placed in a tool so that connector body, cable transition and strain relief come out as one hard, sealed part. Nothing is left to be tightened, taped or gasketed on the line. Specified for ‌DB44 Connector Overmolded Cable For Machine‌ builds, it hands the equipment 44 signal lines through a face smaller than a two-row D-sub of the same count, which matters when panel area is already crowded. Because the mould seals the rear of the shell, the same part also works as a ‌waterproof moulded loom‌, holding out coolant, oil mist and wash-down water where an open solder-cup hood would short out. In practice the harness is ‌injection-molded control wiring‌ for machine builde…

Overmolded Industrial Cables Battery Pack Connection Cables DB-SUB Communication Cables Shielded Signal Wires Auto Sensor Cables